Give your Raspberry Pi Pico / Pico W / Pico 2 Snap-Fit Case project a purpose-built printed home with practical access and a clean GearTechOutpost finish.
Functional design
- Compact two-piece snap-fit shell with no screws
- Open access to the USB connector and BOOTSEL button
- Header-friendly side clearance for prototyping and adapter projects
- The exact CC0 STL is included in this catalog package
Compatibility
Raspberry Pi Pico, Pico W, Pico 2, and Pico 2 W; soldered headers are supported, but the source specifically excludes the factory Pico 2 WH.
What is included
One printed top shell and one printed bottom shell. Raspberry Pi Pico board, USB cable, headers, and all electronics are not included.
Print construction
Source recommendation: 0.4 mm nozzle and 0.20 mm layers. No support requirement was stated.
Made by GearTechOutpost
Printed to order and inspected for obvious print defects before shipment. Layer lines and small surface variations are normal features of fused-filament fabrication.
Designer and license
Design by nmattia. Source: Printables model page. Licensed under CC0 1.0 Public Domain. GearTechOutpost is not affiliated with the designer.
Compatibility statements are based on the designer’s source listing; this development listing is awaiting GearTechOutpost physical fit validation.
Raspberry Pi and other marks belong to their respective owners and are used only to describe compatibility.
Reviews
There are no reviews yet.